Subscribe to our newsletter to receive the latest news and events from TWI:

Subscribe >
Skip to content

Cold Spraying - Cold Spray Coating Deposition

Materials Banner
Innerpage Title Banner
Contact Us CTA
In Cold Spray, powder particles (typically 10 to 40 µm) are accelerated to very high velocities (200 to 1200 m.s-1) by a supersonic compressed gas jet at temperatures below their melting point. Upon impact with the substrate, the particles experience extreme and rapid plastic deformation which disrupts the thin surface oxide films that are present on all metals and alloys. This allows intimate conformal contact between the exposed metal surfaces under high local pressure, permitting bonding to occur and thick layers of deposited material to be built up rapidly. The deposition efficiency is very high, above 90% in some cases.

Whilst thermal spray is widely used in many applications, it uses thermal energy to melt or soften the feedstock. This can cause thermal degradation and partial oxidation of the coating material which may be undesirable. For metallic materials that are very prone to oxidation, thermal spray needs to be conducted under protected atmosphere or a vacuum, introducing extra cost.

The heat input of thermal spray processes introduces residual stress into the coatings, which can limit the thicknesses that can be attained. Furthermore, the thermal balance has to be carefully managed through part cooling and gun manipulation to avoid excessive internal stresses and, in the case of thermally sensitive substrates, potential substrate degradation.

With cold spray however, materials can be deposited without high thermal loads, producing coatings with low porosity and oxygen content.

TWI conducts research to explore the potential of cold spray and optimise the process for specific applications, for example:

  • Repair techniques for lightweight aerospace alloys;
  • Improved biocompatible coatings for medical implants;
  • Thick metallic coatings for thermally sensitive substrates;
  • Bond coatings for oxide ceramics such as thermal barrier coatings (TBCs)

TWI uses a high specification commercial systems (the newly installed state-of-the-art Impact Innovations 5/11 and CGT GmbH Kinetiks ® 4000 47kW). The newly installed 5/11 system offers significant increases in operating temperature and pressure (N2 gas at up to 1100°C and 60 bar) over previous systems, delivering improved coating quality. The cold spray guns can be operated with or without pre-heating the gas and with a variety of spray nozzles. This enables the systems to be configured depending on the requirements.

A number of materials have already been proven to be suitable for cold spraying. These include:

  • Metals (Al, Cu, Ni, Ti, Ag, Zn, Ta, Nb)
  • Refractory metals (Zr, W, Ta)
  • Alloys (steels, Ni alloys, MCrAlYs, Al-alloys)
  • Composites (Cu-W, Al-SiC, Al-Al2O3)

With these materials in mind, a wide range of applications can be explored, with possible end uses in sectors such as aerospace, automotive, oil and gas, power generation, motor sport, medical, petrochemical and electronics.

See further information about Materials & Corrosion Management or please email contactus@twi.co.uk.

For more information please email:


contactus@twi.co.uk